|
Lectra Flypen Plotter Setup StyleCAD can work with almost any plotter used for apparel design. A popular plotter is the Lectra Flypen Plotter, and StyleCAD can take full control over this plotter. Follow these simple directions for setting up StyleCAD to work with a Lectra Flypen Plotter.
Frame Length: 14.959" (38 cm). Please look #2 if encounter problem. Paper Width: 70.87" (180.0 cm) // 90.55" (230 cm) is maxium, 61" may also work. Spacing: 3.94" (10.0 cm) Port: COM1/COM2 Baud: 9600 Protocol: CTS/RTS Parity: Odd or None Stop Bits: 1 Data Bits: 8 To change the communication protocol from Lectra to CTS/RTS on FLYPEN. 1. Press VAL. ("VAL" means "Enter") The screen reads "Mot de passe" (Enter password) 0123456789 Use the left/right arrow keys to enter 1994, the password. Move the cursor to 0123456789 and press VAL. 2. The screen reads "Maintenance CNUM2.4* Language Systeme". Press VAL * If CNUM is 2.5 change Frame Length to 14.520 3.The screen reads "Parameters, Tests, Commandes, Etalonnages" Press VAL 4.The screen reads "Pmachines, Pstylo, Pvitesse, Pconvoye" Press down arrow key 3 times then the screen reads "Pdialogue, Pgain, Poption, Pcourroie" Press VAL 5.The screen reads "Compensation elasticite: (Elasticity Compensation), Oui (Yes)" Press VAL 6.The screen reads "Type de dialogue: (Type of dialog, i.e., Communication Protocols), Lectra" Press right arrow key then "Type de dialogue: Lectra" Now press the upper-arrow key to select CTS/RTS Press VAL 7.The screen reads "Avance Continue: Non" Press QUIT 8.The screen reads "Pdialogue, Pgain, Poption, Pcourroie Press QUIT 9.The screen reads "Voulez-vous sauver (Do you want to save?)" Press VAL 10.Press QUIT until the screen displays "Machine OK". 11. Turn off the machine and then turn it back on. |